Akwụkwọ ntuziaka onye ọrụ SOLITY MT-200C Thread Interface Module

SOLITY MT-200C Thread Interface Module User Manual
SOLITY-logo

SOLITY MT-200C eriri Interface Module

SOLITY-MT-200C-Thread-Interface-Module-product

Atụmatụ

Solity's MT-200C bụ bọọdụ interface / ngwa ngwa na-eji nkwukọrịta ikuku ikuku. Emebere MT-200C iji mejuputa IoT n'ụzọ dị mfe na mkpọchi ọnụ ụzọ.

Ihe Atụmatụ
 

Isi MCU

Cortex-M33, 78MHz @ Ugboro arụ ọrụ kacha
1536 KB @Flash, 256 KB @RAM
Vault echekwara (Boot echekwara, TRNG, njikwa igodo echekwara, wdg…)
 

Ikuku

Frequency : 2405~2480MHz data communication
 
-105 dBm @ Thread Sensitivity
 

 

Ọnọdụ ọrụ

3.2V to 6.4V @VBAT/VDDI
1.3 -> 2.0uA @Deep Sleep Mode
5-> 6 mA @RX Mode Current
19 -> 45 mA @10dBm Output Power
-25 °C ruo 85 °C / Nhọrọ -40 °C ruo 105 °C
Akara ngosi I/O VBAT, VDDI, GND, UART TXD, UART RXD, RESET
Akụkụ 54.3 x 21.6 x 9.7(T) mm

Map Pin Njikọ Mpụga na Nkọwa Ọrụ

Nọmba PIN Aha Pin Ntuziaka mgbaàmà Nkọwa
1 USR_TXD Mpụta Mgbama Mbufe UART
2 USR_RXD Ntinye UART na-anata akara
3 NC Enweghị njikọ  
4 GND Ala Ike  
5 VDDI Ntinye ike Ntinye ike nhọrọ.

Ọ bụrụ na ejighị ntinye VBAT, ọ bụ mpụta mgbe niile voltage ike ntinye.

6 GND Ala Ike  
7 NRST/RF_DATA Ntinye When Reset Signal: Active-low reset signal.

When RF_DATA: Data receive or transmit from/to RF module

8 RF_EN Enweghị njikọ Enable CMT-RX(RF-447MHz) Module
9 NC Enweghị njikọ  
10 NC Enweghị njikọ  
11 NC Enweghị njikọ  
12 GND Ala Ike  
13 VDDI Ntinye ike Same as PIN 5
14 VBAT Ntinye ike Battery Power is between 4.7~ 6.4V.
15 NC Enweghị njikọ  
16 NC Enweghị njikọ  

Ntuziaka ọrụ

Oke ọkụ eletrik
Mara: Nchegbu gafere oke ọkwa nwere ike imebi ngwaọrụ ahụ

Oke Min Oke Nkeji
Ntinye ike DC (VBAT) -0.3 10 V
VDDI(Ntinye ike DC nhọrọ) -0.3 3.8V V
Ugbu a kwa ntụtụ I/O - 50 mA

Electrical Recommended Operating Conditions

Oke Min Oke Nkeji
VBAT (DC ike ọkọnọ) 4.7 6.4 V
VDDI 3.2V 3.6V V
VIH (Ntinye ọkwa dị elu Voltage) 1.71V 3.6V V
VIL (Ntinye Ọkwa dị ala Voltage) 0V 0.3V V

Mmetụta ESD

Oke Min Oke Nkeji
HBM (Nlereanya Ahụ mmadụ) - 2,000 V
MM (Ụdị igwe) - 200 V

Thread Communication Channel

Ọwa Ugboro[MHz]
11 2405
12 2410
13 2415
14 2420
15 2425
16 2430
17 2435
18 2440
19 2445
20 2450
21 2455
22 2460
23 2465
24 2470
25 2475
26 2480

Ngwa

  • The EFR32MG24 Wireless SoCs are ideal for mesh IoT wireless connectivity using Matter, OpenThread and Zigbee.
  • With key features like high-performance 2.4 GHz RF, low current consumption, an AIJML hardware accelerator and Secure Vault, IoT device makers can create smart, robust, and energy-efficient products that are secure from remote and local cyber-attacks. A Cor.
  • tex@LM33 running up to 78 MHz and up to 1536 kB of Flash and 256 kB of RAM pro. resources for demanding applications while leaving room for future growth.

Target applications include:

  • Smart Home – Gateways and hubs, sensors, switches, door locks, smart plugs
  • Lighting  LED bulbs, luminaires
  • Building Automation – Gateways, sensors, switches, location services
  • A1/ML – Predictive maintenance, glass break detection, wake-word detection
  • Njikwa anya
  • Passive Keyless Entry (PKE)
  • Passive Entry Passive Stan (PEPS)
  • Tre Pressure Monitoring System (TPMS)
  • Tire Monitoring Sensor (TMS)
  • N'azụview Igwefoto
  • Garage Door Openers

IHE NDỊ MMADỤ

  • 32-bit ARM@ CortexD-M33 78 MHz maximum operating frequency
  • Up to 1536 kB of flash and 256 kB of RAM
  • High-performance radio with +19.5 dBm output power
  • Energy-efficient design with low active and sleep currents
  • Secure VaultTU
  • AIML Hardware Accelerator
  • Channel sounding
  • AEC-Q100 Grade 1 (selected part numbers only)

Nhazi PCB

SOLITY-MT-200C-Thread-Interface-Module-fig1

Nkwupụta FCC

A nwalere ngwa a wee hụ na ọ dabara na oke maka ngwaọrụ dijitalụ Klas B, dịka akụkụ 15 nke Iwu FCC. Emebere oke ndị a iji nye nchebe ezi uche dị na ya megide nnyonye anya na-emerụ emerụ na ntinye ụlọ. Akụrụngwa a na-ewepụta ojiji ma nwee ike ịgbasa ike ugboro redio yana, ọ bụrụ na etinyeghị ya ma jiri ya dịka ntuziaka ahụ siri dị, nwere ike ibute ndabichi na-emerụ ahụ na nkwukọrịta redio. Agbanyeghị, enweghị nkwa na nnyonye anya agaghị eme na otu nrụnye. Ọ bụrụ na akụrụngwa a na-ebute nnyonye anya na-emerụ ahụ na nnabata redio ma ọ bụ telivishọn, nke enwere ike ikpebi site na ịgbanyụ ma gbanye akụrụngwa, a na-agba onye ọrụ ume ka ọ nwaa idozi nnyonye anya site na otu ma ọ bụ karịa n'ime usoro ndị a:

  • Megharịa ma ọ bụ bugharịa antenna nnata.
  • Mee ka nkewa dị n'etiti akụrụngwa na nnata.
  • Jikọọ akụrụngwa n'ime oghere na sekit dị iche na nke ejikọrọ onye nnata.
  • Kpọtụrụ onye na-ere ahịa ma ọ bụ onye ọrụ redio/TV nwere ahụmahụ maka enyemaka.

Ngwaọrụ a na-akwado akụkụ 15 nke Iwu FCC. A na-arụ ọrụ n'okpuru ọnọdụ abụọ a:

  1. ngwaọrụ a nwere ike ọ gaghị ebute nnyonye anya na-emerụ ahụ
  2. Ngwaọrụ a ga-anabatarịrị nnyonye anya ọ bụla enwetara, gụnyere nnyonye anya nwere ike ibute ọrụ na-achọghị.

Mgbanwe ọ bụla ma ọ bụ mgbanwe ọ bụla nke ndị otu na-ahụ maka nnabata na-akwadoghị nke ọma nwere ike imebi ikike onye ọrụ iji rụọ akụrụngwa a.
IHE dị mkpa:
Nkwupụta Mkpughe Radiation FCC RF:

  • Ngwa a na-akwado oke ikpughe radieshon FCC nke edobere maka gburugburu ebe anaghị achịkwa ya. Ekwesịrị ịwụnye akụrụngwa a ma rụọ ọrụ ya na opekempe 2.5 cm n'etiti radiator & ahụ gị. Agaghị ejikọta ihe nnyefe a ma ọ bụ na-arụ ọrụ na njikọ antenna ma ọ bụ nnyefe ọ bụla ọzọ.
  • This device is intended only for OEM integrators under the following conditions: The antenna must be installed such that 2.5 cm is maintained between the antenna and users, and the transmitter module may not be co-located with any other transmitter or antenna.
  • Ọ bụrụhaala na ezutere ọnọdụ 2 dị n'elu, a gaghị achọ nyocha ndị ọzọ na-ebufe. Agbanyeghị, onye nrụpụta OEM ka na-ahụ maka ịnwale ngwaahịa ha maka njedebe maka nnabata ọ bụla achọrọ na modul a arụnyere (maka ex.ample, ngwaọrụ dijitalụ anapụta, PC peripheral chọrọ, wdg).
  • If the FCC identification number and IC certification number are not visible when the module is installed inside another device, then the outside of the device into which the module is installed must also display a label referring to the enclosed module.
  • This exterior label can use wording such as the following: ‘Contains FCC ID: 2BFPP-MT200C’ and ‘Contains IC: 34741-MT200C ’. Any similar wording that expresses the same meaning may be used.”

This module has been tested and should be used with the antennas:

Ụdị antenna Ọnụ ego kacha elu (dBi) Aha akụkụ
Usoro PCB Antenna 3.0 -
     

RSS-GEN Nkebi 7.1.3
Ngwaọrụ a na-akwado ụkpụrụ RSS enweghị ikike ụlọ ọrụ Canada. A na-arụ ọrụ n'okpuru ọnọdụ abụọ a:

  1. ngwaọrụ a nwere ike ọ gaghị ebute nnyonye anya
  2. Ngwaọrụ a ga-anabatarịrị nnyonye anya ọ bụla, gụnyere nnyonye anya nwere ike bute ọrụ ngwaọrụ ahụ achọghị.

Akwụkwọ / akụrụngwa

PDF thumbnailMT-200C eriri Interface Modul
User Manual · 2BFPP-MT200C, MT-200C Thread Interface Module, MT-200C, Thread Interface Module, Interface Module, Module

Jụọ ajụjụ

Use this section to ask about setup, compatibility, troubleshooting, or anything missing from this manual.

Jụọ ajụjụ

Ask about setup, compatibility, troubleshooting, or anything missing from this manual. Name and email are optional.