Ntuziaka Nwụnye Sistemụ Roth QuickTemp Compact

ọdịnaya zoo

Planlæg hvordan Compact pladerne skal udlægges. OBS.

Always read the full documentation

Wepuo ala subfloor.

Split the turn plate and lay it first.

A ga-ahazi oghere n'etiti efere.

Cut plates from the back, remove any burrs.

Jiri efere mbufe maka ọkpọkọ nri/iji mejupụta oghere.

Vacuum before installation of pipes.

Wụnye ọkpọkọ siri ike / nso n'okirikiri ime n'aka.

Wụnye ọkpọkọ ma mee ule nrụgide.

Vacuum before installation of flooring underlayment

Flooring underlayment. Avoid overlapping.Lay wood floor at a 90° angle to pipes.

ROTH DANMARK A/S · Tlf. +45 47 38 01 21 ·
- Email: service@roth-danmark.dk · roth-danmark.dk
ROTH SVERIGE AB · Tel. +46 40 53 40 90 ·
- Email: service@roth-sverige.se · roth-sverige.se
ROTH NORGE AS · Tel. +47 67 57 54 00 ·
- Email: service@roth-norge.no · roth-norge.no
ROTH FINLAND OY · Puh. +358 (0)19 440 330 ·
- S-posti: service@roth-finland.fi · roth-finland.fi
ROTH UK Ltd. · Phone +44 (0) 1905 453424 ·
- Email: ajụjụ@roth-uk.com · roth-uk.com

Place component A on a flat surface with dimensions 61 cm x 61 cm.
Attach component B to component A using the provided screws (X mm).
Ensure that the maximum load of 2mm per meter is not exceeded.
Connect component C to the assembly following the designated markings.
Secure all components in place as per the assembly diagram.
Continue adding components in the specified order until the structure is complete.
Check for stability and make adjustments if necessary.
Your product is now ready for use!

Gịnị bụ kacha ibu ike nke ngwaahịa?

The maximum load capacity is 2mm per meter.

Achọrọ m ngwaọrụ ọzọ maka mgbakọ?

The assembly requires screws (X mm) provided with the product. No additional tools are necessary.

Enwere ike ịkwasa ngwaahịa a maka nchekwa?

Yes, the product can be disassembled following the reverse order of the installation steps.

Roth QuickTemp Compact System [pdf] Ntuziaka nwụnye
QuickTemp Compact System, QuickTemp, Compact System, System

Hapụ ikwu