Raytac BLE Wireless Module Owner’s Manual

Raytac BLE Wireless Module
Akwụkwọ ntuziaka onye nwe

MARA AKA

Onye mmekọ OEM kwesịrị ịma ka ọ ghara inye onye ọrụ njedebe ozi gbasara otu esi etinye ma ọ bụ wepu modul RF a na ntuziaka onye ọrụ nke ngwaahịa ngwụcha nke jikọtara modul a. Akwụkwọ ntuziaka njedebe ga-agụnye ozi/ịdọ aka ná ntị usoro iwu niile achọrọ dị ka egosiri na ntuziaka onye ọrụ.

UNLICENSED RADIATOR / LICENSE-EXEMPT RADIATOR

Ngwaọrụ a na-akwado akụkụ 15 nke Iwu FCC. A na-arụ ọrụ n'okpuru ọnọdụ abụọ a:
1) ngwaọrụ a nwere ike ọ gaghị ebute nnyonye anya na-emerụ ahụ na
2) a ngwaọrụ ga-anabata ihe ọ bụla na nnyonye anya natara, gụnyere nnyonye anya nke nwere ike ime ka na-achọghị ọrụ.

A dọrọ gị aka na ntị na mgbanwe ma ọ bụ mgbanwe ndị otu na-ahụ maka nnabata na-akwadoghị nke ọma nwere ike imebi ikike onye ọrụ iji rụọ ngwa ahụ.

Ngwaọrụ a nwere ihe mbufe/nnata (s) enweghị ikike na-agbaso Innovation, Science and Economic Development RSS(s) enweghị ikike nke Canada.

A na-arụ ọrụ n'okpuru ọnọdụ abụọ a:
1. Ngwaọrụ a nwere ike ọ gaghị ebute nnyonye anya, yana
2. Ngwaọrụ a ga-anabatarịrị nnyonye anya ọ bụla, gụnyere nnyonye anya nwere ike ime ka arụ ọrụ ngwaọrụ ahụ achọghị.

Ndepụta nke iwu FCC anabatara

A nwalere modul a wee hụ na ọ na-akwado ihe ndị a chọrọ maka nnabata Modular.

• 47 CFR Part 15 Subpart C Intentional Radiators

SUMMARIZE THE SPECIFIC OPERATIONAL USE CONDITIONS

The host device’s end-user manual must include all applicable regulatory notices and

Atụle anya RF EXPOSURE

1. Agaghị ejikọta ihe nnyefe a ma ọ bụ na-arụ ọrụ na njikọ antenna ma ọ bụ nnyefe ọ bụla ọzọ.
2. For portable operation, this device has been tested and meets RF exposure guidelines. When used with an accessory that contains metal may not ensure compliance with RF exposure guidelines.
   • a. For the host product integrated with this modular transmitter as a stand-alone configuration, the maximum conducted power from the original grant shall be retained in order to meet SAR exemption requirements.
   • b. For configuration with multiple transmitters in the same host, routine evaluation or SAR testing for the simultaneous transmission of the co-located transmitters according to KDB 447498 is required. The potable host product shall be evaluated for ensuring to continue compliance FCC rule part 2.1093 & part 1.1310 by. The additional guidance for the portable host products is provided in KDB Publication 996369 D02 and D04.
   • c. For the host product is not installed according to this guide, the module certification will be invalid, and a new grant certification will be required for the host product.

ANTENNAS
This radio transmitter has been approved by Federal Communications Commission and Innovation, Science and Economic Development Canada to operate with the antenna types listed below, with the maximum permissible gain indicated. Antenna types not included in this list that have a gain greater than the maximum gain indicated for any type listed are strictly prohibited for use with this device.

LABEL AND COMPLIANCE INFORMATION (2.8)

The host device integrating this module must be labeled with the following regulatory identifiers to ensure compliance with regulations, these labels must be clearly visible on the exterior of the host device’s enclosure as required by applicable regulatory guidelines.

Contains FCC ID: SH6AN54LV
Contains IC: 8017A-AN54LV

Ozi gbasara ụdị ule na ihe nyocha agbakwunyere

The module can be configured to continuously transmit on a specific frequency with a fixed modulation pattern. This allows evaluation of radiated emissions and spurious emissions in a controlled condition.

These test modes are intended for compliance testing only and must not be enabled during normal operation of the final product.

For more detailed information, please contact the grantee for assistance with test modes needed for module/host compliance test requirements.

Nnwale agbakwunyere, PART 15 NKWUO

Onye na-ebufe modular bụ naanị FCC nyere ikike maka akụkụ iwu akọwapụtara (ya bụ, iwu FCC transmitter) edepụtara na onyinye ahụ, yana na onye nrụpụta ngwaahịa na-ahụ maka nnabata nke iwu FCC ọ bụla nke metụtara onye nnabata na-abụghị nke nnyefe modular. onyinye nke asambodo.

Ngwaahịa ikpeazụ ikpeazụ ka chọrọ nnwale nnabata nke Nkebi 15 nke Subpart B na nnyefe modular arụnyere.

NOTE EMI CONSIDERATIONS

Note that a host manufacture is recommended to use KDB996369 D04 Module Integration Guide recommending as “best practice” RF design engineering testing and evaluation in case non-linear interactions generate additional non-compliant limits due to module placement to host components or properties. For standalone mode, reference the guidance in KDB996369 D04 Module Integration Guide and for simultaneous mode; see KDB996369 D02 Module Q&A Question 12, which permits the host manufacturer to confirm compliance.

HOW TO MAKE CHANGES

A dọrọ gị aka na ntị na mgbanwe ma ọ bụ mgbanwe ndị otu na-ahụ maka nnabata na-akwadoghị nke ọma nwere ike imebi ikike onye ọrụ iji rụọ ngwa ahụ.

Naanị ndị na-enye onyinye ka enyere ikike ịme mgbanwe na-enye ohere, ọ bụrụ na a ga-eji modul ahụ dị iche karịa ọnọdụ enyere, biko kpọtụrụ anyị ka anyị hụ na mgbanwe agaghị emetụta nnabata.