Jiri ntuziaka
Onye mmemme adreesị njedebe
| PRG.PAS.MCS |
| 170 x 112 x 35 mm/ 270 g |
| Plastic case + mechanical keyboard 0°C … 45°C – IP 31 |
| Ike ọkọnọ: 9V (batrị nwere ike ibugharị) |
| Njikọ na ọnụ site na UTP Patch Cable 0.25 cm |
| Adreesị dị maka mmemme: n'etiti "000" na "998" Ịpị "999" na-akwụsị nhazi adreesị. |
Nkọwa
Nke PRG.PAS.MCS programmer allows the programming of the address (apartment number) for all types of terminals in the Ahịrị kpochapụ range: PAS.17A, PAS.27X, PAS.37X, MCS.47X.
This programmer serves as the mobile alternative to the terminal address programming function, enabling the address to be programmed both on-site and in the office, by a single person.
Njikọ na TERMINAL
- UTP Patch USB 0.25 cm
- Azu
- N'ihu
- Onye mmemme PRG.PAS.MCS
- Vidiyo njedebe – ọdịyo (MCS.47X, PAS.27X, PAS.37X)
Gbanye/ Gbanyụọ
- The programmer is turned on by pressing the ON key.
- The programmer turns off:
– 3 seconds after entering the last digit of the programmed address;
– 10 seconds after being turned on, if no key is pressed.
MMEmmemme
Nzọụkwụ 1: Connect the programmer to the terminal.
Nzọụkwụ 2: Pịa ON key on the programmer → The display shows [Adresa biputere].
Nzọụkwụ 3: On the terminal, press and hold the 
igodo.
Nzọụkwụ 4: On the programmer, enter the terminal address to be programmed (3 digits required). After entering the last digit, the terminal will issue a confirmation beep, and the key can be released.
07.2025 INS.PRG.PAS.MCS
Emere na EU site na:
ELECTRA srl
Ụlọ ọrụ Parc Industrial Miroslava
Str. Isi 33, 707307, Jud. Iyi – RO
+40 232 214.370
sales@electra.ro
www.electra.ro
Nkwado
Ụgwọ nke ụlọ ọrụ ELECTRA Building Communications GmbH
Gadnergasse 71, Stockwerk 1, Büro Top 132
1110 Wien – AT
+43 1 810 20 99
sales@electra-automation.at
www.electra-automation.at
Akwụkwọ / akụrụngwa
 |
Electra PAS.17A Terminal Adreesị Mmemme [pdf] Akwụkwọ ntuziaka PAS.17A, PAS.27X, PAS.37X, MCS.47X, PAS.17A Terminal Address Programmer, PAS.17A, Terminal Adreesị Programmer, Adreesị Programmer, Programmer |