COMICA Seekcom S1 Ikuku Intercom Akwụkwọ ntuziaka onye ọrụ

Okwu mmalite

Daalụ maka ịzụrụasing Comica Seekcom S1 Wireless Intercom Headset System.

Isi atụmatụ

• Full-duplex Digital Wireless Talk, Convenient and Efficient
• Free Switch Between Host and Guest, Flexible Combination
• CalMix® AI/ENC Optional Noise Reduction
• High-definition and Intuitive OLED Display
• Dual Antennas Design Enhance Anti-interference up to 500m (Open Area)
• Long Battery Life Up to 12 Hours
• Talk/PTT/Mute Multiple Talk Modes Options
• 24kHz/16bit Specification, High-fidelity Restoration of Sound Details
• Support Overall Broadcasting, One-to-one Talk, Recorder Modes, etc.
• Support 3.5mm External Audio Input/Cascade Extension
• Support USB-C Digital Audio Transmission
• 150Hz-7KHz Ultra-wide Frequency Response
• Powerful Comica Official APP, One-stop Convenient Control
• IPX3 Waterproof Level, Strong Resistance to Rain and Wind
• Ergonomic Design for Light and Comfortable Wear

Product Usage Notice

The Seekcom S1 supports host/guest switching, but only one device can be set as the host and network node in an intercom system group. All other devices must be set as guests (factory default setting). If you need to reset the host/guest settings, the devices should be re-paired.
Please use the original charging case, audio cable and battery. Accessories that are not certified by the manufacturer or are not original replacements may pose dangers such as electric shock, fire, or explosion.
Please prevent it from falling, collision and pounding, otherwise it may cause product failure.
Please do not disassemble this product by yourself to avoid mechanical damage.

Device Storage Notice

Do not place the product near or inside heating equipment, cooking equipment, high-pressure containers, etc., to prevent battery overheating and explosion, such as microwave ovens, induction cookers, electric ovens, electric heaters, pressure cookers, water heaters, gas stoves, etc.
Please store the device in a dry, cool and clean place.
Please keep the device away from the heat, direct sunlight and other corrosive liquids.

Ndepụta nkwakọ ihe

5-set Version:

Igwe ekweisi*5

Batrị *5

Nchaji ntọala*3

USB C-USB A Charging/Data Cable*3

Drawstring Pouch 5

Windmuff*5

Carrying Case 1

Label Sticker 1

Akwụkwọ ntuziaka onye ọrụ*1

Akwụkwọ ikike kaadị*1

Igwe ekweisi*2

Batrị *2

Nchaji ntọala*1

Charging/Data Cable*1 USB C-USB A

Drawstring Pouch 2

Windmuff*2

Ebu akpa*1

Label Sticker*1

Akwụkwọ ntuziaka onye ọrụ*1

Akwụkwọ ikike kaadị*1

1-set Version:
Igwe ekweisi*1

Batrị *1

USB C-USB A

Charging/Data Cable*1

Drawstring Pouch*1

Windmuff*1

Label Sticker*1

Akwụkwọ ntuziaka onye ọrụ*1

Akwụkwọ ikike kaadị*1

Ngwa na ntuziaka

Ekweisi:

1. Igwe okwu Capsule
2. Ihe mkpuchi isi na-agbanwe agbanwe
   It can adjust the length of headset
3. Antenna mpụga
4. Host/Guest Switch Button
   Move up to set it as host; Move down to set it as guest
5. Mgbanwe nke akụkụ batrị
   Move down to open battery compartment cover
6. 3.5mm Port
   1. Plug in external earphones
   2. Input external audio
   3. Cascade extension
7. Broadcasting Button
   Press two times to turn on/off broadcasting or ducking function(switch between these two functions via the APP)
   1. Only the host supports broadcasting function
   2. The ducking function is only available in recorder mode (It can be set via the APP).
      After the ducking function is enabled, pressing the ducking button while the “talk sound” and “recorder monitoring sound” are playing in sync can suppress the “recorder monitoring sound” and make the “talk sound” clearer.
8. Mic Stick
   The flip angle is 270 degrees, flip up to mute, flip down to cancel mute
9. Mute/PTT Button
   Short press to turn muting on/off; long press to enter PTT mode
10. Volume+/Communication Mode Button
    Short press to increase volume(6 levels); long press to turn off/on enhanced mode
    1. Only the host supports communication mode. Once enabled, the signal of guests will be changed in sync
    2. The communication mode is divided into enhanced mode and normal mode. The product is set to enhanced mode by default. If there are special requirements for radio frequency or communication, it can be adjusted according to actual needs
11. Volume-/Bluetooth Reset Button
    Short press to decrease the volume(6 levels); long-press for 5 seconds to reset Bluetooth
    1. Long press the volume + and – buttons in sync to enter pairing state
    2. The Bluetooth function is mainly used to connect the host and mobile phone for APP operation. It’s supposed to reset the bluetooth if you change the phone
12. Ihuenyo OLED
13. Ike/Denoise bọtịnụ
    Long press to power on/off, short press to switch ENC denoise/Al denoise
14. Ọdụ ụgbọ mmiri USB
    Connect to power supply for charging/firmware upgrade/audio transmission
15. Ìhè ihe ngosi na-arụ ọrụ
    

    Steeti	Ìhè ihe ngosi
    Ejikọtaghị ya	Host blinks blue slowly; guest blinks green slowly
    Ijikọta	Host blinks blue quickly; guest blinks green quickly
    Ejikọtara ọnụ	Host keeps on blue; guest keeps on green
    Na-ekwu okwu	Host keeps on blue; guest keeps on green
    Ogbi	Ọkụ na-acha uhie uhie na-aga n'ihu
    Ike dị ala	Ọkụ uhie na -egbu nwayọọ nwayọọ

16. Ọkà okwu
17. Ngwa ngwa
    

    Steeti	Ngwa ngwa
    Muting on/off	Muting on/Muting off
    Mgbanwe olu	Dong
    Host and guest disconnect	Akwụsịla
    Host and guest connect	Ejikọtara
    Host and guest have low power	Ike dị ala
    Denoise Mode Switch	AI Denoise/ENC Denoise
    Broadcasting On	Mgbasa ozi
    Overall PTT (turn on via APP)	PTT On/PTT Off
    Ducking On	Igwu
    Ọnọdụ emelitere	Ding

Screen Display :

Ọrụ Ntuziaka

Ntinye batrị
Open the battery compartment cover, insert the battery into compartment and lock the cover. Please ensure that the battery is installed correctly (As shown in the figure).

Host and Guest Settings
Move the host/guest switch button up or down to set the device as host or guest.

1. Please set the device as host/guest before powering on. If you switch while the device is powered on, you need to restart the device.
2. Only one device can be set as the host and other devices should be set as guests in an intercom system group. If not, the device will not work properly

Gbanyụọ/ Gbanyụọ
Long press the power button to turn the headset on/off.

Host and Guest Pairing

The device is paired by default. If the device is reset as host/guest, or there is a pairing abnormality, please follow the steps to pair again:

1. Pịa ogologo the volume + and – buttons in sync to enter pairing mode;
2. After successful pairing, the host indicator light keeps on blue and the guest indicator light keeps on green.

PTT
Press and hold the PTT button to enter PTT talk mode; release the button to enter mute mode; short press to turn off mute and back to the normal talk mode.

Ogbi
Short press the mute/PTT button, or flip the mic stick up to activate mute function. Voice prompt: na-akụ ụda.

Mgbanwe olu
The volume level ranges from 1-6. Press the volume + or volume – button to adjust the volume. Voice prompt: Dong

Noise Reduction Mode Switch
Obere pịa the denoise button to switch between ENC denoise/Al denoise.

Ngbanwe ọnọdụ ọrụ
The device is set to normal mode by default. It can be changed to recorder mode via the APP.
Ụdị nkịtị: Users can plug an external headphone with a mic into the 3.5mm port to communicate, or connect with another set of Seekcom S1 intercom headset system (host or guest) for cascade extension.

Recorder mode: Users can connect a recording device to the 3.5mm port to monitor the recording status.

Broadcast Button Function Customize
In host mode, device is set as broadcasting function by default. The ducking function is switchable after turning on recorder mode via APP. In guest mode, device does not support broadcasting function. The ducking function is switchable after turning on recorder mode via APP.

1. Only the host supports broadcasting function
2. The ducking function is only available in recorder mode (It can be set via the APP). After the ducking function is enabled, pressing the ducking button while the “talk sound” and “recorder monitoring sound” are playing in sync can suppress the “recorder monitoring sound” and make the “talk sound” clearer

Nbufe ọdịyo USB
Connect to the computer via the audio cable for real-time communication, such as online meeting, etc

Otu esi eyi
Adjust the extendable headband to an appropriate length, put on the headset and point the microphone capsule toward your mouth.

Ịchaji
Method 1. Take out the battery and place it in the charging base, then connect the power supply to charge.
Method 2. Plug the charging cable to the USB port of the headset, then connect the power supply to charge.

APP Connection and Operation (Connected with the host)

1. Search and download the “Comica Audio” APP in your mobile phone’s APP store;
   Comica Audio
   
2. Turn on the Bluetooth of your mobile phone and get close to the host;
3. Open the APP to search and add the device: Seekcom S1;
   
   
4. After successful pairing, you can check the device state and operate all functions via the APP
   
   
   1. If the Bluetooth pairing fails or the device needs to be connected to a new mobile phone, please long press the Bluetooth reset button for 5 seconds to reset it.
   2. One-key ducking, recorder mode, one-to-one talk, overall PTT, voice prompt language switch, ect., can be set or switched via the APP.

Nweta nkwalite

Nkwalite ngwa ngwa

1. Download the Seekcom S1 firmware upgrade package to the computer from the Comica official websaịtị.
2. after turning off the device, press and hold the volume + and power button in sync to enter copy mode. Copy the firmware upgrade package to the Seekcom S1-UPDATE folder.
3. Disconnect the USB audio cable and restart the device to upgrade automatically.

Nweta nkwalite njikọ Bluetooth
Open the “Comica Audio” APP and connect with Seekcom S1. Then go to the device homepage and select settings icon in the upper right corner-Univer-sal-Firmware Upgrade.

Nkọwapụta

Websaịtị: comica-audio.com
Facebook: Akụkọ ihe mere eme nke Comica Audio Tech Global
Instagebulu: Comica Audio
YouTube: Comica Audio

Akwụkwọ / akụrụngwa

COMICA Seekcom S1 Wireless Intercom Headset System [pdf] Akwụkwọ ntuziaka onye ọrụ 118, Seekcom S1 Wireless Intercom Headset System, Seekcom S1, Wireless Intercom Headset System, Intercom Headset System, Headset System

Ntụaka

• Akwụkwọ ntuziaka onye ọrụ