Okwu mmalite
Thank you for choosing the KOKIDO XTROJET 420 Cordless Robotic Pool Cleaner. This manual provides essential information for the safe and efficient operation, maintenance, and troubleshooting of your new pool cleaner. Please read it thoroughly before first use and retain it for future reference.
Ozi nchekwa dị mkpa
- Always ensure the pool cleaner is switched off and disconnected from the charger before handling or maintenance.
- Ejila ihe nhicha ahụ rụọ ọrụ ma ọ bụrụ na batrị ma ọ bụ chaja emebie.
- Debe ụmụaka na anụ ụlọ n'ebe dị anya n'ebe a na-asa ahụ mgbe a na-arụ ọrụ nhicha ahụ.
- Use only the provided charger and battery.
- The cleaner is designed for flat-bottom pools up to 850 sq ft (30 feet in length).
- This device is not intended for cleaning algae or very fine silt particles.
Ihe ngwugwu
Chọpụta na akụrụngwa niile dị:
- Main Unit (KOKIDO XTROJET 420 Robotic Pool Cleaner)
- chaja
- Nko eweghachi
- Nozzle Cleaning Brush
- Akwụkwọ ntuziaka (akwụkwọ a)
Melite
1. Ịchaji Unit
Before first use, fully charge the robotic pool cleaner. The charging time is approximately 5-6 hours for a full charge, providing up to 75 minutes of cleaning time.
- Ensure the cleaner is dry before connecting the charger.
- Chọta ebe a na-agba chaja na ihe nhicha ahụ.
- Connect the charger to the unit and then plug it into a power outlet.
- The power indicator lights will show red during charging and turn green when fully charged.
2. Adjusting Cleaning Paths
The XTROJET 420 features an adjustable 3-way path selection switch to optimize cleaning for various pool sizes and shapes. Adjust the pin placement on the front swivel wheel according to your pool dimensions.
Ntuziaka ọrụ
1. Itinye ihe nhicha n'ime ọdọ mmiri
- Hụ na ihe nhicha ahụ nwere chajị zuru oke.
- Turn on the cleaner by flipping the switch on the top. The indicator light will turn blue.
- Gently lower the cleaner into the pool. It will slowly fill with water and sink to the bottom.
- The motor will automatically activate once the unit is fully submerged and detects water.
2. Usoro nhicha
The XTROJET 420 will navigate across the pool bottom, collecting debris. It operates for approximately 75 minutes per charge.
- The cleaner is equipped with a 15.9 GPM suction system and three rollers to enhance cleaning efficiency.
- It effectively captures soft leaves (up to 6 inches), small twigs, dead bugs, sand, and coarse gravel.
- Mara: This cleaner is not designed for algae or very fine silt. For these types of debris, additional pool maintenance methods may be required.
3. Auto-Parking and Retrieval
When the battery is low or the cleaning cycle is complete, the cleaner will automatically park itself near the pool side for easy retrieval.
- Use the included retrieval hook to gently lift the cleaner from the pool.
- Allow excess water to drain from the unit before removing it completely from the pool.
- Turn off the cleaner using the switch on top.
Nlekọta
1. Cleaning the Debris Compartment and Filter
Regular cleaning of the debris compartment and filter is crucial for optimal performance.
- After each use, unlatch the four clips on the cleaner to open the top cover.
- Wepu nkata nzacha.
- Empty collected debris from the compartment and rinse both the compartment and the stainless steel filter thoroughly with a garden hose.
- Ensure all debris is removed from the 250µ stainless steel filter.
- Reassemble the filter and close the top cover, ensuring all clips are securely latched.
2. General Pool Maintenance
For a healthy and clean pool, consider these additional steps:
- Skim off leaves and debris from the surface.
- Brush sediment from pool walls to prevent algae.
- Keep your filtration pump running effectively.
- Check and backwash your filter regularly.
- Add chemicals and test your pH value to maintain water balance.
Nchọpụta nsogbu
| Nsogbu | Ihe nwere ike ime | Ngwọta |
|---|---|---|
| Cleaner does not move or gets stuck in one spot. | Incorrect path setting for pool size/shape; Obstruction; Low battery. | Adjust the 3-way path selection switch. Check for and remove any large obstructions. Ensure the unit is fully charged. |
| Cleaner anaghị anakọta ihe mkpofu nke ọma. | Filter basket is full or clogged; Debris is too fine (silt/algae). | Clean the debris compartment and filter thoroughly. Note that the cleaner is not designed for very fine silt or algae. |
| Small pin for wheel adjustment is lost. | Detached during cleaning or maintenance. | Ensure the pin is securely in place before operation. Contact customer service for replacement if lost. |
| Cleaner does not turn on when placed in water. | Not fully submerged; Battery not charged; Power switch off. | Ensure the cleaner is fully submerged. Verify battery is charged. Check that the power switch is in the 'ON' position. |
Nkọwapụta
| Njirimara | Nkọwa |
|---|---|
| Aha Nlereanya | XTROJET 420 (RC48) |
| Isi Iyi Ike | Akwadoro batrị (1 batrị lithium ion gụnyere) |
| Ụdị batrị | Lithium-Ion, 11.1 Volts, 4000 mAh |
| Oge ọrụ | 75 nkeji |
| Oge Nchaji | 5-6 awa |
| Ike imi | galọn 15.9 kwa nkeji (GPM) |
| Debris Capacity | 1.2 galọn |
| nzacha | 250µ Stainless Steel Filter, 154 sq inches Effective Filtration Area (EFA) |
| Ụdị ọdọ mmiri | Above-Ground and Flat Pools (up to 30 feet / 850 sq ft) |
| Akụkụ ngwaahịa | 14.5"L x 15"W x 9"H |
| Ibu Ibu | 14.35 pound (6.52 n'arọ) |
| Ihe onwunwe | Igwe anaghị agba nchara |
Akwụkwọ ikike & Nkwado
The KOKIDO XTROJET 420 comes with a 1-year warranty.
For customer service and support, please refer to the contact information provided with your product or visit the official Kokido website. You can also scan the QR code on the product for user manual and videos: https://qrs.ly/npgbdc4
